Change the order of sub-inspections in an inspection

You can easily change the order in which sub-inspections should be performed during an inspection to logically match your inspection workflow.

For example, you may choose to do this on an inspection for a vehicle if you want the inspector to do the electrical sub-inspection prior to doing the fluids check sub-inspection. You can also reorder the tests within a sub-inspection.

It is helpful to know that:

• The order in which sub-inspections display during the inspection is determined by the order in which the sub-inspection buttons display from top to bottom on the Inspection Editor.

• Each time you add a sub-inspection to an inspection, GainSeeker automatically adds it to the bottom of the list of sub-inspections in the Inspection panel

• You can change the order of sub-inspections by simply repositioning the sub-inspection buttons in the Inspection panel

• Example: For the F1 Truck inspection, the Traceability sub-inspection will occur prior to the Fluid check and Electrical system check sub-inspections.

See another example

To change the order of sub-inspections:

• Click the sub-inspection button you want to reposition in the Inspection panel.
• Then, click the green up-or-down arrow buttons at the top of the Inspection panel until the sub-inspection button is correctly repositioned.

Related topic

The GainSeeker Inspections module: Create PC and mobile inspections