Parameters to specify the initial screen size and location

For the following modules:

Add to target line:

How these modules function:

  • GainSeeker Charts

  • System Administration

  • Dynamic Reports

WindowState=number

Each time you start this shortcut, the program will be launched with the main screen maximized or minimized. Valid options for the number are:

number

window state:

1

maximized (overrides the Size and Location parameters below)

2

minimized

If any other number is specified, the main screen will be launched in normal (sized) mode.

Size=height,width

Each time you start this shortcut, the program will be launched with the main screen sized at the height and width you specify (in pixels).

Location=x,y

Each time you start this shortcut, the program will be launched with the upper left corner of main screen sized at the x and y positions you specify (in pixels).

  • SPC Data Entry

  • SPC Database Monitor

  • Enterprise Dashboard

  • LaunchPad

-FW:width

-FH:height

Each time you start this shortcut, the program will be launched at the width and height that you specify (in pixels). You cannot drag the edges of the program screen to change its size.

If the width is less than 800, the program will be launched in PDA mode. For more information, see Parameters to launch the program in PDA mode.

If the LaunchPad module is started with these parameters, then these parameters will also be applied to any SPC Data Entry, SPC Database Monitor or Enterprise Dashboard sessions that are launched from this instance of the LaunchPad.