Standard overrides settings for DMS charts

If you want to analyze data as if its standards were configured differently—without actually changing those standards—you can expand the Standard overrides tree and temporarily override the settings. Information about each of these settings is featured in this topic.

You can assign default settings to charts in the GainSeeker System Administration module. See Chart Defaults settings

 

Contents  [Hide]

 

Navigating to these settings

The Standard overrides node is located at the top level on the Settings tab:

For help with using tree structures like the one on the Settings tab, see Navigating Tree Structures

Some of the standard settings will impact the statistics that you report in different ways. These standard settings can be grouped as follows:

Settings that will only change the statistic that reports that standard setting:

Standard override setting:

Affects this statistic:

Improvement start date

Improvement start date

Improvement start value

Improvement start value

Memo

Memo

Part Number

Part Number

Process

Process

Standard Sample size

Standard Sample size

Settings that will also affect the calculation of some other statistics (in addition to changing the statistics that report these standard settings):

Standard override setting:

Affects these statistics:

Also affects the calculation of other statistics, such as:

Cost per Unit

Cost per Unit

Total NCU Cost

Lower Gate

Lower Gate

% in Gate, % out of Gate

Opportunities per Unit

Opportunities per Unit

Yield, Total Sample size, % Defects

Upper Gate

Upper Gate

% in Gate, % out of Gate

More information

 For more information on individual settings in standards or processes, see DMS Processes and DMS Standards.